1. Clean the wall surface and make a rough surface. If it is a smooth surface with low water absorption such as plastic wood, it must be covered with iron wire mesh and a rough bottom surface, and then pave it after sufficient maintenance.
2. Before sticking the rocks, be sure to arrange the rocks on the flat ground to get the best effect and then pave them in the order of arrangement. Don't put rocks of similar size, shape, and color next to each other.
3. White cement above No. 425, ordinary cement (the ratio of cement: sand: 801 glue is 1:2:0.05), ceramic bonding agent (please pay attention to the instructions for use of the bonding agent) high-performance special bonding agent can be used as glue.
4. Fully wet the rock, apply the adhesive at the center of the rock bottom to pile up in the shape of a mountain (a thin layer of adhesive can be applied to the bottom of the brick when pasting antique tiles) If you accidentally soil the surface on a large area, you need to use a brush in time Use after washing.
5. Paste the corner first. Press fully to make the adhesive squeeze out around the rock (some products do not need corners).
